IAME 125 cc LEOPARD TaG engine Assembly Instructions And User's Manual page 10

11
CONNECT THE SECOND HOSE BETWEEN
THE FITTINGS ON THE RADIATOR OUTLET
AND THE PUMP INLET.
CONNECT THE
THE FITTINGS ON THE PUMP OUTLET AND
THE ENGINE INLET (SEE FIG. 10).
TIGHTEN WITH STEEL CLAMPS.
BEFORE STARTING THE ENGINE FOLLOW THESE RECOMMENDATIONS:
?? Unscrew the cap on the radiator and loosen the breather plug on the engine head.
?? Fill the radiator until the water comes out from the plug on the head (there is no air in
the system now) and the radiator is completely filled. Tighten the cap (the system
contains appr. 1 lt. of water).
?? It is advisable to put a small cup to recover water from the breather on the cap in
case of boiling water.
?? After the engine run-in, check
necessary.
18/10/02 mod. C
THIRD HOSE BETWEEN
Fig.10
the water level in the radiator and top up if
8
MAN-016 D