Maintenance - York TLHA18-30OSAAAD Installation Manual

MAINTENANCE

ousehol
Drain
Cleaner
No
Filter Handle
ir reshening
ilter
1
2
WARNING
It is necessary to stop the air conditioner and disconnect the power
supply before cleaning.
C
CAUTION
• Use a dry cloth to wipe the indoor unit and remote controller.
• A cloth dampened with cold water may be used on the indoor unit if it
is very dirty.
• The front panel of the indoor unit can be removed and cleaned with
water. Then wipe it with a dry cloth.
• o not use a chemically treated cloth or duster to clean the unit.
• o not use benzine, thinner, polishing powder, or similar solvents for
cleaning. These may cause the plastic surface to crack or deform.
C
A clogged air lter reduces the cooling ef ciency of this
the lter once every 2 weeks.
1. Lift the indoor unit panel up to an angle until it stops with a clicking
sound.
2. Take hold of the handle of the air lter and lift it up slightly to take it out
from the lter holder, then pull it downwards.
3. Remove the AIR FILTER from the indoor unit.
• Clean the AIR FILTER once two weeks.
• Clean the AIR FILTER with a vacuum cleaner or water, then dry it up
in cool place.
4. Remove the air freshening lter from its support frame (The installation
and removing method of the air freshening lter is di erent depending
on the models, see the pictures marked
• Clean the air freshening lter at least once a month, and replace it
every 4 5 months.
• Clean it with vacuum cleaner, then dry it in cool place.
5. Install the air freshening lter back into position.
. Insert the upper portion of air lter back into the unit taking care that the
left and right edges line up correctly and place lter into position.
M
If you plan to idle the unit for a long time, perform the following:
(1) Operate the fan for about half a day to dry the inside of the unit.
(2) Stop the air conditioner and disconnect power.
Remove the batteries from the remote controller.
(3) The outdoor unit re uires periodic maintenance and cleaning. o not
attempt to do this yourself.
Contact your dealer or servicer.
C
• Check that the wiring is not broken o or disconnected.
• Check that the air lter is installed.
• Check if the air outlet or inlet is blocked after the air conditioner
has not been used for a long time.
CAUTION
• o not touch the metal parts of the unit when removing the lter. In uries
can occur when handling sharp metal edges.
• o not use water to clean inside the air conditioner.
Exposure to water can destroy the insulation, leading to possible
electric shock.
• When cleaning the unit, rst make sure that the power and circuit
breaker are turned o .
unit. Please clean
1 and 2 on the left.)
ENGLISH
EN