2N EasyGate User Manual page 28

Roaming enable/disable
You can make EasyGate work even if it is registered to a foreign GSM network.
Setting options:
-Disable
register again in within 5 minutes.
-Enable
Default setting: Disable
Incoming calls enable
With this parameter you can reject all incoming calls.
Setting options:
Enable
Disable
Default setting: Enable
8.3.5. Service Parameters
Hardware version
EasyGate hardware version - for information only (cannot be modified). Must be
used for communication with the manufacturer.
Firmware version
EasyGate firmware version - EasyGate central processor program version. The
manufacturer can issue upgrades to extend functions. To load new firmware into
EasyGate use the Upgrade function. Keep communicating with the manufacturer.
Serial number
EasyGate serial number - for information only (cannot be changed). Must be
used for communication with the manufacturer.
GSM operator lock
Refer to GSM & SIM Parameters.
COM enable
With this parameter you can enable/disable the serial interface function. You can
disable communication in the operating mode, maintaining the special
programming mode after power up.
Setting options: YES/NO
Default setting: YES
-The GSM module logs out of a foreign network and attempts to
-EasyGate works in any GSM network.
- Incoming calls ring on the telephone line.
- Incoming calls are rejected.
23
Function No.:
Function No.:
Function No.:
Function No.:
Function No.:
Function No.:
Function No.:
42
43
-
-
-
-
50