Table of Contents
Advertisement
Troubleshooting Guide
If your gate opener does not function properly after it is installed, use this guide before calling the GTO Service Department.
18 Vac Transformer ............................................................................................18.0 to 22.0 Vac, 2200 mA
5 W Solar panel (single) ....................................................................................18.0 to 22.0 Vdc, 300 mA
* measure voltage at panel and control box.
Two 12 V, 7 amp hour Batteries .....................................................................12.5 to 13.5 Vdc 7.0 Ah
*measure voltage at battery terminals with battery disconnected from circuit board
Charging circuit .................................................................................................13.3 to 14.8 Vdc
*measure voltage at battery terminals with battery connected to circuit board and GREEN "POWER IN"
LED is ON.
Audible Feedback
Symptom
1 short beep upon
activation
1 short beep upon
power up
Continuous
Uninterrupted Alarm
1 beep with 10 seconds
off
1 beep then 2 beeps
1 beep with 2 seconds
off
3 beeps with 2 seconds
off
VOLTAGE READINGS
Diagnosis
Blown Fuse
Low or Bad Battery
Loose Battery Connection
Circuit Board Powered
Up & Ready
Circuit Board Senses an
Obstruction
Low Battery Condition
Master Motor Terminals
Shorted
Master Arm Limit Switch
Error
Master Arm Rev Counter
Error
Check:
• Fuse
• Battery Under Load
• Battery Harness Connections
• Normal Operation
• Path of Gate
• Gate for Level and Plumb
• Stall Force Adjustment
• Disconnect Safety Devices
• Rev Counter
• Fuses
• Battery Harness Connections
• Battery Under Load
• Connections to Master Inputs
• Master Arm Power Cable
• Motor
• Circuit Board
• Connections to Master Inputs
• Master Arm Power Cable
• Connections to Master Inputs
• Master Arm Power Cable
• Rev Counter
33
Advertisement
Table of Contents
