Table of Contents
Advertisement
IMPORTANT: Before making any changes to DIP switches turn control box off!
N
GR
W HT
BL
U
N
BR
G
OR
D
RE
BL
K
N
GR
W HT
U
BL
N
BR
G
OR
D
RE
K
BL
M
CO
M
CO
E
CL
CY
TY
FE
SA
IT
EX
OW
SH
AD
OS
E
CL
GE
ED
EN
OP
GE
ED
N
GR
BL
K
D
RE
DIP Switch #1 - Soft Start/Stop
The soft start/stop feature slowly starts the gate as it
begins to open or close and slows the gate as it comes
to the opened or closed position. This saves wear and
tear on the gate and gate opener system.
DIP Switch #2 - Warning Buzzer
The warning buzzer alerts you when the gate opener
is beginning to either open or close the gate. It sounds
for the first 2 seconds in each direction. It also sounds
a warning when the gate obstructs two times in one
cycle. Switching this to OFF only disables the open
and close warning not the obstruction warning.
DIP Switch #3 - Push/Pull-to-Open
If your gate opens into the property the DIP Switch is
set to the OFF position (factory setting). If your gate
opens out from the property the DIP Switch must be
set to the ON position. NOTE: if you have a Push-to-
Open gate application you will need a Push-to-Open
bracket (see Push-to-Open Instructions on page 16).
Control Box Settings
DIP Switches
*factory
*factory
presets shown
presets shown
DIP#1
ON**___Soft start enabled (factory preset).
OFF
__Soft start disabled.
DIP#2
ON**___Buzzer warning enabled (factory preset).
OFF __ Buzzer warning disabled.
DIP#3
ON*___Push-to-open.
OFF*__Pull-to-open (factory preset).
DIP#4
NOTE: Not applicable for single gate operator.
DIP Switch #4 -
Not applicable for single gate operator.
24
Advertisement
Table of Contents
