Table of Contents
Advertisement
Long 3/8" Bit
Drill
Level
Clamp
• Low voltage wire will be needed to run from the
transformer to the control box; length depends
upon the distance between the transformer power
supply and the control box. See Transformer Wiring
Installation on page 19, and the accessory catalog.
• PVC conduit.
• If your gate is more than 1000' away from an ac
power source you will need to use at least one GTO
5 watt solar panel to trickle charge the battery. See
the accessory catalog (Do not use both transformer
and solar).
• If you have thin walled tube or panel gates, see
Recommended Reinforcement Examples in "Quick
Reference Guide" after Step 3 of "Mounting Opener
to Gate" section.
Before You Begin
Tools Needed
5/16" Bit
Pliers
Hack Saw
9/16"
wrench
Adjustable
x2
Items Not Included
®
Marking
Pen
1/2"
wrench
Philips Head
Screwdriver
Stripper
Wrench
• Depending on the type of gate, a horizontal cross
member or mounting plate may be needed to mount
the front of the opener and gate bracket to the gate.
See Gate Bracket Mounting Examples in "Quick
Reference Guide" after Step 3 of "Mounting Opener
to Gate" section.
• Surge protection for transformer.
• Some types of installations require u-bolts.
• If the gate is a push-to-open refer to page 15 in
Installation Manual.
• Additional washers or a metal plate may be needed
for wooden post.
• Outlet in weatherproof cover.
• Strain relief nuts for accessory devices.
• If post is more than 6", bolts longer than 8" are
needed.
11
Center
Punch
Hammer
Flat Head
Screwdriver
Wire
Small
Flat Head
Measure
Tape
Advertisement
Table of Contents
