Table of Contents
Advertisement
Connecting Additional Devices
Connecting GTO Automatic Lock
GTO Lock:
For use exclusively with GTO Lock (FM142 or FM144).
Connecting other devices to these terminals may cause incorrect
operation and void your warranty. You do not use the lock board
with this control board.
Connecting Other Auxiliary Devices
• These 2 terminals are normally open, dry-contact (no voltage) relay ouput.
• These 2 terminals are ON (shorted) whenever the gate is moving and OFF (opened) otherwise.
• These 2 terminals maximum rating is 24Vdc, 1 Amp.
Maintenance & Troubleshooting
• On all gates weighing 250 lb. or more, routinely
grease the ball bearing hinges at least 4 times a year;
more frequently if the gates are near a coastal area.
• Keeping a few mothballs in the control box will
discourage insects from entering it and damaging the
control board.
Maintenance Tips
• Clean the push-pull tube with a soft, dry cloth and
apply silicone spray to it at least once per month.
32
POWER
INPUT
GTO 18VOLT
TRANSF. OR
SOLAR PANEL
Wire from
Automatic
GTO Lock
GTO Lock Connection:
Connect the red and black leads from the lock to the GTO LOCK
terminal on the gate operator control board.
(Mag Locks, Sirens, Lights. . .}
CONTROL OUTPUTS
AUX
LOCK
RLY
PWR
Advertisement
Table of Contents
