Table of Contents
Advertisement
HD Ultra-mini Bullet IR IP Camera
ICA-3110
C. I/O PIN definition
• GND (Ground): Initial state is LOW
• DO (Digital Output): DC 5V
• DI (Digital Input): Max. 50mA, DC 5V
2. I/O Setup
A. Click I/O Setting from the system setup page via IE, and check "Out1" to enable I/O signal.
B. Output Test
After the external input and output hardware is installed, you can use the "Relay Out" bottom
on the live video page to test if DO / Relay Out works.
1) OnOff Switch mode:
Click "ON" and the camera will trigger the external output device. For example, your alarm
buzzer will continuously ring. You can manually break off the output signal by clicking "OFF".
57
Advertisement
Table of Contents
