Advertisement
Instructions for Use
This fireplace can be operated either by the switches located on the top right hand side
of the fireplace or by supplied remote control.
Manual Operation
The switches are located on the top right hand side of the fireplace. The standby switch
•
must first be turned on.
Press the
•
appear to indicate that the function is ON.
Press the
•
flame colors will change every 10 seconds.
•
Press the 750W button once for low heat setting; press twice to turn off the heat.
•
Press the 1500W button once for high heat setting; press twice to turn off the heat.
Remote Control Operation
•
The power switch
on; the fireplace will beep to indicate that it is powered up.
•
Insert 2 x 1.5V AAA batteries (not included) into the battery compartment of the remote
control. Make sure they are inserted with the correct polarity. (The -/+ signs placed in the
proper position.) Securely close the battery compartment cover.
•
It takes some time for the receiver to respond to the transmitter. Do not press any
buttons on the remote control more than once within two seconds in order for the
fireplace to operate properly.
•
Press the standby button
flame effect.
Press the "750W" button once for low heat setting. Press the button again to switch off
•
the heat.
•
Press the "1500W" button once for high heat setting. Press the button again to switch off
the heat.
Press the "DIMMER" button to operate the dimmer.
•
button once to turn on the fireplace and flame effect. A red indicator light will
button for 3 seconds to operate the automatic color change function. The
located at the right hand side of the fireplace must first be switched
on the remote control once to turn on the fireplace with
7
Advertisement
