McQuay RAH 047C Installation And Maintenance Manual page 120

Applied rooftop systems air handler
Hide thumbs Also See for RAH 047C:
Table of Contents

Advertisement

Rooftop Equipment Warranty Regist. Form
Warranty Registration Form (continued)
VI. GAS & OIL BURNER CHECK, TEST, & START
Specifications:
For gas, see Forced Draft Gas Burner Installation and Maintenance Bulletin.
For oil, see Oil Fired Furnace Installation and Maintenance Bulletin.
A. (Gas/Oil) Furnace model no. __________________
B. (Gas/Oil) Burner model no. __________________
C. (Gas) Type firing:
D. (Oil) Type firing start:
E. (Gas) Rated firing rate:_________________ MBH input
F. (Oil) Rated firing rate: _________________ GPH, #2 fuel oil
G. (Gas/Oil) Altitude: ___________________ ft. above sea level
H. Is there a circulating tank? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
VII. GAS BURNER CHECK, TEST, & START
A. Input: _______________________________ CFH
B. Gas pressure at burner: _________________ inches wc
C. CO
: __________________________ %
2
D. CO
: __________________________ %
2
E. Pilot flame only: _______________ microamps (steady at low fire)
F. Pilot Tap-gas pressure:__________________ inches wc
G. Motor only/burner: FLA__________________ running amps
H. High limit control OK?. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
I. Flame safeguard: ________________ microamps
J. Flame failure shutoff: ________________ seconds
K. Airswitch OK?. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
L. High Gas Pressure Switch OK? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
M. Low Gas Pressure Switch OK? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
N. Main Gas Valve Close-off OK?. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
VIII. OIL BURNER CHECK, TEST & START
A. Nozzle(s): Type/manufacturer
B. Nozzle pressure: _______________________ psi
C. CO
: __________________________ %
2
D. Smoke spot: number ______________
E. Running amps ________________ FLA
F. Flame safeguard: microamps _________________
G. High limit control OK?. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
H. Flame failure shutoff OK?. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
I. Ignition failure check OK? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
.
IX
Have all electronic or electrical controls been checked, adjusted, and tested for proper operation per the
installation and maintenance bulletins?
X. MAINTAINING MICROTECH CONTROL PARAMETER RECORDS
After the unit is checked, tested, and started and the final control parameters are set, record the final settings. Keep these records on file and
update whenever changes to the control parameters are made. Keeping a record facilitates any required analysis and troubleshooting of the
system operation and facilitates restoration after a controller replacement.
Signature: ______________________________________________________
RETURN COMPLETED FORM TO:
McQuay International Warranty Department, 13600 Industrial Park Boulevard, Minneapolis, MN 55441
Please list any additional comments that could affect the operation of this unit; e.g., shipping damage, failed components, adverse installation
applications, etc., on a separate sheet and attach to this form.
120
Serial no. ___________________
Single
Stage two
Full fire start
Low fire start
GPH
Stage modulation
Angle
Pattern manufacturer
Startup date: ___________________________________
No
N/A
No
N/A
No
N/A
No
N/A
No
N/A
No
N/A
No
N/A
No
N/A
No
N/A
Yes
No
N/A
McQuay IM 987

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rah 077cRds 800cRds 802c

Table of Contents