Start-Up; What This Chapter Contains; Introduction - ABB MicroFlex e150 User Manual

Start-up

What this chapter contains

This chapter describes software installation and the start-up procedure of the drive.

Introduction

Before powering the MicroFlex e150 you will need to connect it to the PC using a
USB or Ethernet cable and install the Mint WorkBench software. This includes a
number of applications and utilities to allow you to configure, tune and program the
MicroFlex e150. Mint WorkBench and other utilities can be found on the Mint Motion
Toolkit CD (OPT-SW-001), or downloaded from www.abbmotion.com.
The PC must have the following minimum specification:
Processor
RAM
Hard disk space
CD-ROM
Serial port
Screen
Mouse
Operating system
Minimum specification
1 GHz
512 MB
2 GB
A CD-ROM drive
USB port
or
Ethernet* port
1024 x 768, 16-bit color
A mouse or similar pointing device
Windows XP or newer, 32-bit or 64-bit
Start-up 89
9