Commands Description; Setting Form Length - Compuprint 914N User Manual

Appendix A

Commands Description

Setting Form Length

ESC C {n}
This command sets the form length to the number of lines specified by {n} at the
current vertical spacing. The form length is memorized as physical position on the
page. The current paper position is assumed as top of the form.
ESC C NUL {n}
This command sets the form length to the number of inches specified by {n}. The
current position of the paper is assumed as top of form.
ESC N {n}
This sequence sets the number of lines {n} to be skipped at the bottom of a page.
{n} must be less than the current form length. The bottom of form distance is
memorized as physical position on the page. This can be reset by the ESC O
command or by changing the form length setting.
ESC O
This sequence sets the number of lines of skip perforation to {0}.
A.6
Sets form length in number of lines.
1B 43 {n}
27 67 {n}
1 ≤ n ≤ 127
Sets form length in inches.
1B 43 00 {n}
27 67 0 {n}
1 ≤ n ≤ 22
Set bottom of form (skip over perforation).
1B 4E {n}
27 78 {n}
1≤ n ≤ 255
Cancels skip-over perforation.
1B 4F
27 79
A78401740-001