JVC SR-VS30U Instructions Manual page 57

Filename [VS30U_3-EN.fm]
VS30U_3-EN.fm Page 57 Friday, February 1, 2002 1:18 PM
A
If the camcorder has no S-VIDEO output connector ...
Recorder
Mini-plug cable
(not supplied)
(JVC camcorder only)
EDIT
Camcorder
To AUDIO/VIDEO
OUT connector
Player
C
If the camcorder has a DV IN/OUT connector ...
Recorder
DV IN/OUT
DV cable (VC-VDV204)
(not supplied)
DV IN/
OUT
Camcorder
EDIT
Player
Simultaneous Dubbing
It is possible to perform recording simultaneously on both the VHS deck and the DV deck from the same external input.
A Press AUX (number key "0") and /or PR to select the appropriate input mode depending on the connectors being used.
B Press DV to select the DV deck. Press and hold
C Press VHS to select the VHS deck. Press and hold
D Engage the Play mode of the connected device.
E Press
to start recording on both the VHS deck and DV deck.
4
F Press
to stop recording on the VHS deck.
8
G Press DV to select the DV deck, then press
Page 57
VIDEO input
1 3 2
PAUSE
connector
AUDIO input
Audio/Video cable
(supplied)
1 3 2
PAUSE
connector
Mini-plug cable
(not supplied)
(JVC camcorder only)
and press
9
and press
9
to stop recording on the DV deck.
8
B
If the camcorder has an S-VIDEO output connector ...
Recorder
Mini-plug cable
(not supplied)
(JVC camcorder only)
EDIT
Camcorder
AUDIO OUT
S-VIDEO OUT
Player
NOTES:
About DV IN/OUT connector
To output digital signal when dubbing from the VHS deck to
other device through the DV IN/OUT connector, press
and then press PLAY ( ) to start playback on the VHS deck.
4
To input digital signal when dubbing from other device to
the VHS deck through the DV IN/OUT connector, press
then S-VHS, and then press REC (
VHS deck.
It is possible to control the DV deck from the AVC protocol-
equipped device that is connected to the DV IN/OUT
connector. To control the VHS deck, use the buttons on this
VCR and the Remote.
Dubbing is also possible using the rear panel connectors.
All necessary cables can be obtained from your dealer.
When you select "EDIT" to dub tapes in step 4, be sure to select
"AUTO" (or "NORM" when "VIDEO CALIBRATION" is set to
"OFF") after you finish dubbing the tapes.
When you are editing through the DV IN/OUT connector, the
VCR will stop if the signal is interrupted.
When connecting this VCR to a device equipped with a DV
input connector, be sure to use the optional DV cable
(VC-VDV204).
so that the DV deck enters the Record Pause mode.
7
so that the VHS deck enters the Record Pause mode.
7
Masterpage:Right-Full-NoTitle0
57
EN
S-VIDEO input
1 3 2
PAUSE
connector
AUDIO
input
Yellow:
not connected
Audio/video cable
(supplied)
S-Video cable
(supplied)
,
) to start recording on the
7
February 1, 2002 1:18 pm