JVC SR-VS30U Instructions Manual page 72

Filename [VS30U_4-EN.fm]
VS30U_4-EN.fm Page 72 Thursday, January 31, 2002 3:45 PM
72
EN
VHS MODE SET
S-VHS ET
8
ON
OFF
S-VHS MODE
8
ON
OFF
Page 72
You can record on VHS cassettes with S-VHS picture quality. Tapes recorded using
this function can be played back on a VCR equipped with the S-VHS ET function.
When this function is set to "ON", the S-VHS indicator lights up on the front
display panel.
NOTES:
You can activate the S-VHS ET function only before you start recording on a VHS cassette.
Before recording, make sure that "VIDEO CALIBRATION" is set to "ON". (
You cannot activate the S-VHS ET function ...
... while recording is in progress.
... while timer-recording or Instant Timer Recording (
... while Video Calibration (
The S-VHS ET function does not work with S-VHS cassettes.
To keep the highest quality recording and playback pictures over a long period of time,
S-VHS recording on S-VHS cassettes is recommended.
Use of high grade tapes is recommended for S-VHS ET recordings. On some tapes, picture
quality will not improve even if the S-VHS ET function is used. Check the recording quality
before you start important recordings.
You can play back a tape recorded using the S-VHS ET function on most of S-VHS VCRs and
of VHS VCRs equipped with SQPB (S-VHS QUASI PLAYBACK) function. (Notice some
VCRs are not compatible with the S-VHS ET function.)
While playing back a tape recorded using the S-VHS ET function on some VCRs, noise may
appear. (If playback picture becomes blurred or interrupted, use a cleaning cassette.)
In the high-speed search, still, slow-motion or frame-by-frame playback modes (
noise may appear. If these modes are performed frequently on a tape recorded using the
S-VHS ET function, the tape may be damaged and the picture may be deteriorated.
Your VCR can record in S-VHS (Super VHS), S-VHS ET or VHS.
To record in S-VHS:
Set "S-VHS MODE" to "ON". Then, insert a cassette marked "S-VHS". The S-VHS
indicator lights up on the front display panel.
The S-VHS recording mode is selected.
To record in S-VHS ET on a VHS cassette:
Set "S-VHS ET" to "ON". (
The S-VHS indicator lights up on the front display panel.
To record in VHS:
Insert a cassette marked "VHS".
Set "S-VHS ET" to "OFF". (
To record in VHS on an S-VHS cassette:
Insert a cassette marked "S-VHS". The S-VHS indicator lights up on the front
display panel. Then, set "S-VHS MODE" to "OFF". The S-VHS indicator goes off.
The VHS recording mode is selected.
NOTE:
When playing back a tape that has been recorded in S-VHS or S-VHS ET, the S-VHS indicator
lights up on the front display panel regardless of the "S-VHS MODE" setting.
SUBSIDIARY SETTINGS (cont.)
* The default setting is bold in the table below.
pg. 32) is in progress.
pg. 35) is in progress.
See above.) Then, insert a cassette marked "VHS".
See above.)
Masterpage:Left-FullCol
pg. 73)
pg. 28),
January 31, 2002 3:45 pm