Table of Contents
Advertisement
Error Codes and Messages
Some error codes and messages may appear on the TV screen when operating the VCR. Refer to the chart below for
the solution.
CODE
102
"REC PROHIBITED"
103
"REC PROHIBITED"
105
"CAN NOT REC DIGITAL INPUT BY
S-VHS/VHS"
"CHOOSE ANALOG INPUT"
108
"REC BY HS MODE"
201
"WAIT A MINUTE
CALIBRATING. . ."
202
"COPY RESTRICTED PROG OUTPUT
480i VIDEO"
203
"COPY RESTRICTED PROG CAN NOT
PLAY BACK"
205
"CAN NOT PLAY BACK THIS TAPE"
301
"TOO MANY i.LINK INSTRUMENTS
READ INST.BOOK"
302
"COPY RESTRICTED PROG OUTPUT
480i VIDEO"
MESSAGE
An attempt was made to make a D-VHS recording of a program for
which only the analog information is copy protected.
While making a D-VHS recording of a program, a signal in which
only the analog information is copy protected was input to this VCR.
An attempt was made to dub a D-VHS recording of a digitally copy
protected program.
While dubbing a D-VHS recording, digitally copy protected
information was input to this VCR.
This VCR supports copy protection technologies such as DTLA, and
cannot record programs that employ digital copy protection.
An attempt was made to make an S-VHS/VHS recording of a signal
from an i.LINK device.
The i.LINK connector on this VCR is intended only for D-VHS
recording. This VCR does not convert a digital signal into an analog
signal for recording. Switch to the analog input for recording.
When 720p, 1080i signals are recorded in STD/LS3/LS5 mode, select
HS mode to record program properly.
Normal playback is being prevented by mosaic noise, etc.
Wait while the VCR calibrates itself so that it can output a normal
image.
When playing back a program that was copy protected in 1080i,
720p, or 480p mode, the VCR down-converts to 480i mode for output.
An attempt was made to play back a tape containing a copy protected
program.
Even if you record a copy protected program, this VCR cannot play it
back.
An attempt was made to play back a tape containing an invalid
D-VHS recording.
A signal containing too much data was input to the i.LINK connector
on this VCR.
There are too many devices with i.LINK connectors, such as VCRs
and digital video cameras, connected to the i.LINK connector on
this VCR. Turn off any devices that are not in use.
When playing back a program that was copy protected in 1080i,
720p, or 480p mode, the VCR down-converts to 480i mode for output.
EN
DESCRIPTION
51
Advertisement
Table of Contents
