JVC SR-VD400E Instructions Manual page 39

Additional settings "ADDITIONAL"
"SUPERIMPOSE"
"ON"
"OFF"
"GRAY BACK"
"ON"
"OFF"
"POWER SAVE"
"ON"
"OFF"
When this function is set to "ON", various VCR status information (on-screen display)
appears on the screen.
NOTES:
● When you use this VCR as the playback VCR for editing a tape, be sure to set this
function to "OFF"; otherwise, the VCR status information (on-screen display) will be
recorded on the edited tape.
● If you select a channel on which no signal is received, the channel number is displayed
regardless of this function setting.
When this function is set to "ON", the VCR changes the screen into the gray back screen
automatically when receiving a channel not in use.
When this function is set to "ON", you can reduce the power consumption. While the
VCR is turned off, the front display panel does not show the clock.
When this function is set to "ON", an i.LINK device cannot be recognized. As a result, it
is not possible to record a program using the digital tuner's* timer function. In addition
the device does not pass along data if it is in a branched connection.
* For details of a digital tuner, refer to the instruction manual of the digital tuner.
NOTE:
It takes some time until VCR completes its set up when you turn on the VCR.
* The default setting is bold in the table below.
CONTINUED ON NEXT PAGE A
39
EN