Table of Contents
Advertisement
OTHER PROBLEMS
SYMPTOM
1. The auxiliary input cannot be
changed.
2. The Remote will not operate your TV.
3. "PM" blinks on the front display
panel.
4. The subtitles and the menu screen are
overlapped.
MOISTURE CONDENSATION
Moisture in the air will condense on the VCR when you move it from a cold place to a warm place, or under
extremely humid conditions—just as water droplets form on the surface of a glass filled with cold liquid. Moisture
condensation on the head drum will cause damage to the tape. In conditions where condensation may occur, keep the
VCR turned on for a few hours to evaporate the moisture before inserting a tape.
ABOUT HEAD CLEANING
Accumulation of dirt and other particles on the video heads may cause the playback picture to become blurred or
interrupted. Be sure to contact your nearest JVC dealer if such troubles occur.
ATTENTION
This VCR contains microcomputers. External electronic noise or interference can cause microcomputer to
malfunction. If the VCR does not operate correctly switch its power off and unplug the AC power cord from the AC
supply. Wait for a while and then plug the power back in. Eject and check the condition of the cassette. If
everything appears normal, you can operate the VCR as usual.
POSSIBLE CAUSE
Recording is in progress.
The brand codes are set incorrectly.
The VCR do not work properly.
The subtitle display on the TV is set to
on.
EN
CORRECTIVE ACTION
Press [PAUSE ( 8 )] to pause the record-
ing, change auxiliary inputs, then press
[PLAY ( 3 )] to resume recording.
Reset the correct brand codes
(
page 45).
Unplug the AC power plug once, then
plug it again.
Set it to off.
49
Advertisement
Table of Contents
