Error Codes And Messages - JVC HM-DH30000U Instructions Manual

Error Codes and Messages

Some error codes and messages may appear on the TV screen when operating the VCR. Refer to the chart below for
the solution.
CODE
102 REC PROHIBITED
103
REC PROHIBITED
104
CAN NOT DECODE VIDEO OR AUDIO
USE SET TOP BOX OR HDTV TUNER
105
INPUT BY S-VHS/VHS
CHOOSE ANALOG INPUT
107
CAN NOT REC DIGITAL INPUT BY
S-VHS/VHS
USE ANALOG TIMER PROGRAMING
200
CAN NOT DECODE VIDEO OR AUDIO
USE SET TOP BOX OR HDTV TUNER
201
WAIT A MINUTE
CALIBRATING. . .
202
COPY RESTRICTED PROG OUTPUT
480I VIDEO
203
COPY RESTRICTED PROG CAN NOT
PLAY BACK
205
CAN NOT PLAY BACK THIS TAPE
300
CAN NOT DECODE VIDEO OR AUDIO
USE SET TOP BOX OR HDTV TUNER
301
TOO MANY i.LINK INSTRUMENTS
READ INST.BOOK
302
COPY RESTRICTED PROG OUTPUT
480I VIDEO
* A digital tuner will be released in the future.
MESSAGE
An attempt was made to make a D-VHS recording of a program for
which only the analog information is copy protected.
While making a D-VHS recording of a program, a signal in which
only the analog information is copy protected was input to this VCR.
An attempt was made to dub a D-VHS recording of a digitally copy
protected program.
While dubbing a D-VHS recording, digitally copy protected
information was input to this VCR.
This VCR supports copy protection technologies such as DTLA, and
cannot record programs that employ digital copy protection.
A signal that is not compatible with this VCR was input.
Switch to the analog input for recording. (It may be possible to play
back the material if using a digital tuner*, etc.)
An attempt was made to make an S-VHS/VHS recording of a signal
from an i.LINK device other than a digital tuner*.
The i.LINK connector on this VCR is intended only for D-VHS
recording. This VCR does not convert a digital signal into an analog
signal for recording. Switch to the analog input for recording.
An attempt was made to make an S-VHS/VHS recording using the
timer function with "i.LINK" selected on the digital tuner* side.
The i.LINK connector on this VCR is intended only for D-VHS
recording. This VCR does not convert a digital signal into an analog
signal for recording. Also, it is not possible to make a D-VHS
recording on VHS tape. Switch to the analog input for recording.
An attempt was made to play back a signal that is not supported by
this VCR.
To play back the signal, use the digital tuner*, etc., that was used to
record the signal.
Normal playback is being prevented by mosaic noise, etc.
Wait while the VCR calibrates itself so that it can output a normal
image.
When playing back a program that was copy protected in 1080i,
720p, or 480p mode, the VCR down-converts to 480i mode for output.
An attempt was made to play back a tape containing a copy protected
program.
Even if you record a copy protected program, this VCR cannot play it
back.
An attempt was made to play back a tape containing an invalid
D-VHS recording.
A signal format that is not supported by this VCR was input.
Use a digital tuner*, etc.
A signal containing too much data was input to the i.LINK connector
on this VCR.
There are too many devices with i.LINK connectors, such as digital
tuners and digital video cameras, connected to the i.LINK connector
on this VCR. Turn off any devices that are not in use.
When playing back a program that was copy protected in 1080i,
720p, or 480p mode, the VCR down-converts to 480i mode for output.
DESCRIPTION
73
EN