Video Navigation; Navigation Playback - JVC SR-VD400E Instructions Manual

D-vhs digital recorder

Hide thumbs

Table Of Contents

Table of Contents

Navigation

Playback

Turn on the VCR and the TV, and select the AV mode

on the TV.

Set the [VCR/TV/CABLE/DBS] selector on the Remote

to [VCR].

VCR

CABLE

/DBS

-1,4

NOTES:

If you press [NAVI] while Video Navigation is deactivated, the Navigation Set Up screen appears. Set "NAVIGATION" to "ON"

(

page 25).

Video Navigation playback is possible only with the tape recorded on this VCR.

To record the date and time as the program title in this VCR's memory, make sure the VCR's clock is set correctly before recording.

To record the program information in this VCR's memory, you must record each program for over the minimum recording time; 5 min

for the D-VHS (HS) mode, 10 min for the D-VHS (STD) mode, 30 min for the D-VHS (LS3) mode, 50 min for the D-VHS (LS5) mode,

5 min for the S-VHS/VHS (SP) mode and 15 min for S-VHS/VHS (EP) mode.

Video Navigation may not work properly for some tapes.

During playback or when searching for the beginning of a program, a VCR might find two different tape numbers recorded on a tape.

After you remove this tape, the tape will be assigned just one tape number (the smaller one). After this, the higher tape number will be

missing from the memory's tape number list.

Tape program information is stored in this VCR's memory. If this VCR's memory is damaged and the program information is lost, it is

impossible to restore that information.

After recording a tape on this VCR, write the tape number on a label and affix the label to the tape in order to allow you to find the tape

by its number.

The on-screen display is output to the TV with S-VIDEO, VIDEO, COMPONENT VIDEO signal in 480i image format.

This function is useful when you want to quickly find

programs you have recorded on a tape using this VCR. This

function allows you to select a program to watch, and then

automatically search for the beginning of the program.

Load a cassette

Insert a tape recorded on this VCR.

The VCR turns on automatically.

The tape will run for a few seconds while the

VCR searches for the tape number recorded. If

tape number is found, it will be shown on the

TV screen if "SUPERIMPOSE" is set to "ON"

(

The counter is reset automatically, however, it is

not completely reset to "0:00:00".

If the cassette's record safety tab has been

removed, playback begins automatically.

Access Video Navigation screen

Press [NAVI].

After pressing

[NAVI], it may take

a few seconds to

access the Title

screen while the

VCR searches for

the Video

Navigation information.

Select program

Press [%ﬁ] to select the program you want to

watch, then press [OK].

Start playback

-2,3

Press [@ #] to move the arrow to "PLAY", then

presss [OK].

Playback starts automatically after the selected

program is located.