Table of Contents
Advertisement
9 TROUBLESHOOTING
9-1 Error Indication
Error indications are shown on the display whenever there
are problems with cassette loading, unloading or
mechanism operation.
5
When a problem occurs, the error indication E- – – blinks.
5
When any one of the error indications is shown, a 12 V
warning signal is output from the rear panel's WARNING
OUT connector (for E-01 to E07, and E-11 during
recording) (only when the <TERMINAL SEL 2> menu
function switch is set to "WARN").
5
When the function menu switch <WARNING BUZZER>
is set to ON, the buzzer sounds whenever a problem
occurs (for E-01 to E07, and E-11 during recording).
When an error indication appears or the buzzer
sounds, turn the operating mode off and then on again
to clear the error indication and buzzer sound.
When the error indication E- – – is shown, turning the
operating mode on again may not clear the problem. In
this case, consult your local JVC dealer (for E-01 to E-
07).
Error
Contents
indication
E-01
Problem with loading operation
E-02
Problem with unloading operation
E-03
Problem with supply reel rotation
E-04
Problem with drum rotation
E-05
Problem with take-up reel rotation
E-06
Problem with capstan rotation
E-07
Problem with eject operation
E-09
Error with recording check
(inferior recording performance)
E-10
Insufficient capacity of the built-in
battery for backup (Displayed
only in the operating off mode.)
E-11
No video signals input to the
[VIDEO IN] connector
This unit uses a microprocessor and may not function properly if there is external noise or interference. In this case, turn
the operating mode off and unplug the power cord from the AC outlet. Then plug the power cord in again and check
operation.
Buzzer sound
VCR operation
The operating mode is turned off.
The operating mode is turned off.
The operating mode is turned off.
The operating mode is turned off.
The operating mode is turned off.
The operating mode is turned off.
The operating mode is turned off.
Cleans the heads with the VCR's
head cleaner.
—
—
Display section
TIME MODE
Error indication
VTR MODE 1
(SHARPNESS)
NORMAL
(AUTO REC)
OFF
(REC CHECK)
MANUAL
(TAPE END MODE)
REPEAT
(INDEX SEARCH)
OFF
(CAMERA SW)
OFF
(TAPE END BUZZER)
OFF
(WARNING BUZZER)
ON
PRESS (SHIFT, SET)
PRESS (MENU)
TO
END
VTR mode 1 setting screen
Measures
Turn the operating mode on again.
Turn the operating mode on again.
Turn the operating mode on again.
Turn the operating mode on again.
Turn the operating mode on again.
Turn the operating mode on again.
Turn the operating mode on again.
Cleans the heads with the head
cleaning tape, then check the
recording picture quality again. The
tape may be defective. Replace the
tape and check again.
If the picture quality is still inferior,
consult your local JVC dealer.
Contact your local JVC dealer to
replace the built-in battery.
Input video signals.
41
Advertisement
Table of Contents
