Table of Contents
Advertisement
ImageSafe
CABLING PROCEDURE
To connect the ImageSafe Scanner to a local computer locate the power and USB cables
contained in the box. Once the cables have been located perform the following steps:
1.
Connect the USB plug to the ImageSafe Scanner as shown in Figures 2-2 and 2-3.
2.
On the AC power adapter, connect the power plug to the device
3.
On the AC power adapter, connect the plug to wall outlet
4.
The LED indicator on the ImageSafe Scanner should turn on to a steady green. The
LED indicator on the ImageSafe Scanner is located on the slot where the check is first
inserted for reading (see figure 2.1). If the LED does not turn green refer to the LED
indication section.
Do not place the ImageSafe Scanner within 6 inches of a
computer monitor or power supply. These devices may cause
undesirable interference with the check reading operation.
6
Caution
Figure 2-2. ImageSafe Cabling
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IMAGESAFE SCANNER and is the answer not in the manual?
Questions and answers