Camera Adjustment Via Osd Menu - Santec VTC-652DNP User Manual

3. Camera adjustment via OSD menu

In this chapter, the OSD menu is described. The OSD menus is accessed by the button
MENU (ENTER) and it is adjusted by the buttons TELE (up), WIDE (down), NEAR (right) and
FAR (left)
3.1 OSD overview
3.2 OSD main menu
How to save OSD settings:

Use the arrow down key ("wide") to go to <END <EXIT>".

Use the arrow left key ("far") or arrow right key ("near") key to select one of the
following options:
o END <EXIT>: Changed settings are only valid until the next camera reboot,
i.e. the settings will be lost after the next camera reboot.
o END <SAVE & EXIT>:
The settings will be saved (will also be available after the next camera reboot).
o END <DEFAULT & EXIT>:
Settings will be restored to factory default settings.

Confirm your selection by pressing the "MENU" key.
_________________________________________________________________________________
Bedienungsanleitung / User manual VTC-652DNP
1. camera title
2. status of focus mode
3. status of zoom position
4. camera ID
Please note:
If you change the OSD settings,
please make sure to save them
otherwise these settings will be
lost and the old settings will be
restored when the camera is
rebooted.
- 40 -