Advertisement
Warning:
In the following installation procedures, do not disconnect the
Mediatrix LP Series while the LEDs are flashing.
Thank you for choosing the Mediatrix LP Series. This Quick Start will help you to properly connect all of the cables to the Mediatrix LP unit and access its
web interface.
Please read the Mediatrix LP Hardware Installation Guide for detailed installation information and the Dgw v2.0 Software
Configuration Guide for in-depth configuration information.
Step 1
Connecting Cables
The following describes how to connect the various cables to the Mediatrix LP. There are many flavours of the Mediatrix LP unit (Mediatrix LP16 and
Mediatrix LP24). Because of this, some of the information provided may not apply to your particular Mediatrix LP unit model.
Before you begin, make sure that you have a working network connection. Then follow these steps to install the Mediatrix LP.
4
5
1.
Before you begin, be sure that the Mediatrix LP unit is powered off.
2.
Connect the power cord to its connector on the rear of the unit. Do not connect the other end of the power cord to an electrical outlet
3.
Connect analog telephones or fax machines into the phone/fax connectors.
The Mediatrix LP16 has 8 connectors, while the Mediatrix LP24 has 16 connectors.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
4.
Connect a 10/100 BaseT Ethernet RJ-45 cable into the
supplies TCP/IP network access (e.g., router, switch, hub or computer).
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
5.
Connect a 10/100 BaseT Ethernet RJ-45 cable into the
computer.
You can either use a crossover or straight Ethernet cable because it performs automatic MDI / MDIX detection. Use a standard
telecommunication cord with a minimum of 26 AWG wire size.
© 2011, Media5 Corporation
3
5
ETH1
ETH2
Installation – MGCP/NCS
3
3
3
4
connector of the unit; connect the other end to a compatible Ethernet interface that
connector of the Mediatrix LP and connect the other end to the network card of a
Discover the Power of
Mediatrix LP Series
3
Document Revision 01
5
Advertisement
Table of Contents
Related Manuals for Media5 Mediatrix LP Series
Summary of Contents for Media5 Mediatrix LP Series
- Page 1 In the following installation procedures, do not disconnect the Mediatrix LP Series while the LEDs are flashing. Thank you for choosing the Mediatrix LP Series. This Quick Start will help you to properly connect all of the cables to the Mediatrix LP unit and access its web interface.
- Page 2 Dynamic IP Address Discovery Before connecting the Mediatrix LP unit to the network, Media5 strongly suggests that you reserve an IP address in your DHCP server for the unit you are about to connect. DHCP servers reserve IP addresses for specific devices by using a unique identifier for each device. The Mediatrix LP unit's unique identifier is its media access control (MAC) address.
- Page 3 ETH1 interface. The Mediatrix LP software parameters are fully programmable by using the SNMP protocol. You may use the Media5’ Unit Manager Network product to access and configure these parameters. Download the Unit Manager Product and its Quick Start document from the Mediatrix Download Portal.
Need help?
Do you have a question about the Mediatrix LP Series and is the answer not in the manual?
Questions and answers