Connecting To The Mains Supply; Electrical Information (Uk And Eire Only) - Pace DSL4000 User Manual

Connecting to the mains supply

On either the rear panel or the base of the set-top box,
there is a label which specifies the correct mains supply
for the set-top box. Do not connect the set-top box to
any supply other than this.
The supplied mains lead has a 2-way connector at one
end and a mains plug at the other. Insert the 2-way
connector into your set-top box before you insert the
plug into the mains supply.
The only way to disconnect this set-top box from the
mains is to remove the mains lead plug from the mains
socket-outlet. Therefore you must install the set-top
box near to the mains socket-outlet, which should be
easily accessible.
Whenever you disconnect the set-top box from the
mains supply, always remove the plug from the mains
socket-outlet before you remove the 2-way connector
from the mains connector on the rear panel of the set-
top box.
If you are in any doubt about the mains lead, its plug or its
connection, consult a competent electrician.
Electrical information
(UK and Eire only)
Mains plug and its fuse
The supplied mains plug may be a non-rewireable type or a
rewireable type. Both types contain an approved 3 A fuse.
If you need to replace the fuse, you must use an ASTA- or
BSI-approved BS 1362 fuse, rated at 3 A and marked as
shown below.
or
The non-rewireable plug has its fuse beneath a fuse
cover on its face. Use a screwdriver to lever off the
fuse cover, replace the fuse with a new one and refit
its cover.
Never use a plug if its fuse cover is missing.
AM
The fuse is inside the rewireable plug. Use a
screwdriver to remove the plug's back cover. Never
put the plug into the mains socket when its cover is
removed. Lever out the fuse and replace it with a
new one. Replace the plug's back cover.
FUSE of correct value
E
N
L
WARNING!
If the supplied mains plug is not suitable for your mains
socket-outlet, DO NOT plug it in. Remove its fuse and
then cut the plug off the lead. Destroy the severed plug
immediately to avoid the shock hazard which would exist if
this were to be plugged into a mains socket.
Fit an appropriate mains plug on the lead. If this plug
contains a fuse, it should be as described above. If you are
using a non-fused plug, an external fuse must not exceed
5 A.
3