Table of Contents
Advertisement
To set the system to Ready Mode:
1.
Ensure that all the doors are closed and that the gear selector is in the neutral position.
2.
With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. press
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the engine will go on running.
5.
Exit the vehicle and close the door.
6.
Press and hold either:
a.
to lock the doors and shut down the engine;
LOCK
b.
to unlock the doors and shut down the engine;
UNLOCK
c.
START/STOP
Remaining In Ready Mode
Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, should
any of the following occur, the vehicle will exit Ready Mode – thus eliminating the remote start
option until Ready Mode is restored:
• Door opened;
• Hood opened;
• Brake pedal pressed;
• Parking brake disengaged;
• Ignition key turned to the
Should any of the above occur, Ready Mode will be cancelled.
Note: The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes
(parking lights).
Remote-starting
Press the
START/STOP
that the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine
will start. The parking lights will remain
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
of vehicles could cause them to remain
battery.
Driving Off
With the vehicle running under remote control, press the
doors. Enter the vehicle and do the following:
•
Turn the ignition key to the
position while the engine is running. This would cause the starter motor to re-engage.)
•
Press the brake pedal to disengage the remote starter unit.
P. 8
,
LOCK
UNLOCK
to shut down the engine without affecting the doors.
IGNITION ON (RUN)
button for approx. 1 second. The parking lights will come
during the pre-programmed run time of the engine.
ON
. It is recommended to leave the settings on
HIGH
even after remote starter shut down, resulting in a dead
ON
IGNITION ON (RUN)
or
on the transmitter.
START/STOP
position.
. Leaving the headlight switch
OFF
button to disarm and unlock the
UNLOCK
position. (Do not turn the key to the
to inform you
ON
or
LOW
on certain types
ON
AS-2360TW User Guide
MEDIUM
CRANK
Advertisement
Table of Contents
