ARIES User Manual_
Routine maintenance to be performed
Bearings (only for Technical Support Service)
Check bearings regularly for wear or damage according to the following timescales:
WHEELS:
BELT TIGHTENING PULLEY
FAN SHAFT:
TENSIONING UNIT
SANDING DRUM:
MOTOR SHAFT:
Drum pulleys and motor pulleys (for the user)
Regularly check that the groove (2) of the pulley has not sunk otherwise the belt (1) will operate on the bottom (3)
of the pulley itself.
WARNING
Pulleys with sunken grooves cause the belts to slip and the correct power will not be transferred to the
drum/suction pipe.
For example, this situation can easily occur if the machine loses power during operation.
They should therefore be replaced.
Spare parts
Always use K&T spare parts.
Failure to use K&T spare parts, or repairs/adjustments carried out by unauthorised personnel, will invalidate the
guarantee and any resulting liability.
The machine must only be repaired by qualified personnel. This electric equipment is compliant with the
relevant safety legislation.
Repairs must be carried out by qualified personnel using K&T spare parts, otherwise the user may suffer serious
injury.
March 2013 Edition
after the first
after the first
after the first
after the first
after the first
after the first
2500 hours
2500 hours
2500 hours
2500 hours
5000 hours
5000 hours
24