Table of Contents
Advertisement
ARIES User Manual_
Machine adjustment procedures
Adjusting sanding pressure
To vary drum pressure on the floor, use the adjustment knob (pos. 14 fig. E
1.
Turn the adjustment knob clockwise to
decrease drum pressure on the floor.
Wall edge castor
A support with a free castor has been fitted to avoid damage to the skirting board or wall when sanding along the
wall.
WARNING
Before starting work position the castor correctly by unscrewing the
screw (pos. 12 fig. C), moving the support to the required position and
tightening the screws.
March 2013 Edition
The wall edge castor is correctly positioned
when the machine is approximately 8 mm
away from the wall with the castor up against
it.
)
and proceed as follows:
2.
Turn the adjustment knob anti-clockwise to
increase drum pressure on the floor.
20
Advertisement
Table of Contents
