Table of Contents
Advertisement
ARIES User Manual_
Starting the machine
IMPORTANT
If starting the machine is difficult in winter when temperatures are very low remove the abrasive belt and
start the motor, letting it idle for several minutes. Replace the belt and repeat the start up operations
described above.
WARNING
A safety contactor is fitted to the machine. If the power fails when sanding the contactor is activated
automatically, stopping the machine from accidentally starting up when the power is restored. To
recommence sanding repeat the start-up operations described above.
Machine adjustment procedures
Procedures for centring the abrasive belt
The belt centres automatically on starting the motor.
WARNING
The belt is positioned correctly when:
-
it runs along the inside of the tensioning drum (A)
-
it protrudes approximately 2 mm outside the rubber drum
(B)
Procedures for centring the abrasive belt
When first fitted the belt may be in the wrong position. In this case use the spanner as shown (pos. 13 fig. D)
(marked by the yellow arrow), and proceed as follows:
March 2013 Edition
Stand in front of the machine to check that
following operation the belt is positioned correctly.
Turning the screws anti-clockwise moves the belt
towards the outside (1).
Turning the screws clockwise moves the belt
towards the inside (2).
19
Advertisement
Table of Contents
