Table of Contents
Advertisement
ARIES User Manual_
Commencing operation
Instructions for assembly following transportation
7. Lift the drum with the lever (pos. 4 fig. A).
Instructions for electrical connection
CAUTION
WARNING
WARNING
WARNING
HAZARD
Cables, extensions and plugs
Only use approved cables. The maximum recommended cable length is 7m; for greater lengths use cables with a
larger cross-section.
CAUTION
WARNING
WARNING
March 2013 Edition
This machine only operates with the voltage and frequency shown on the machine data
plate. Before connecting the cable to the power supply ensure the correct voltage and
frequency are available
Do not expose the machine to rain. This machine is intended for dry use only.
Keep the machine in a dry building and do not use it in damp or wet places.
If the machine is not connected correctly to the electricity network death due to
electrocution may occur. To prevent electric shocks always use a three wire electrical
system connected to earth. For maximum protection against electric shocks use a
circuit protected with a differential cut-out switch.
Tampering with the earthing plug in any way may result in death from electrocution. Do
not cut, remove or break the earthing plug. If the socket does not match the plug
consult a qualified electrician.
If the machine is used with a damaged plug or power supply cable death may occur
from electrocution. If cables or plugs are worn or damaged in any way, have them
replaced by the manufacturer or the K&T technical support service or similarly qualified
person, in order to prevent risks to safety.
Using the machine with unsuitable cable cross-sections and/or excessively long cables
may cause injury or damage to people or objects.
The machine must never be moved using its cable and the cable must never be pulled
when disconnecting from the socket.
Keep the cable away from sources of heat, oil and sharp edges.
8. Connect the power supply cable to the machine and power
supply.
.
11
Advertisement
Table of Contents
