Playback; Basic Playback - JVC HR-S9850EU Instructions Manual

20
EN

Basic Playback

Turn on the TV and select the video channel (or
AV mode).
A
Load a cassette.
Make sure the window side is up, the rear label side is
facing you and the arrow on the front of the cassette is
pointed toward the recorder.
Do not apply too much pressure when inserting.
The recorder's power comes on automatically.
While "– – – –" is blinking on the front display panel, the tape
will run for a few seconds to search for the tape number.
If the record safety tab has been removed, playback begins
automatically.
B
Find the programme start point.
If the tape is advanced past the start point, press 3 or
turn the JOG dial to the left. To go forward, press 5 or
turn the JOG dial to the right.
C
Start playback.
Press . "BEST" appears blinking in the recorder's front
4
display panel during automatic tracking. (
D
Stop playback.
Press on the remote control or
8
front panel. Then press
0
Clean the video heads using a dry cleaning
cassette — TCL-2UX — when:
Rough, poor picture appears while a tape is played back.
The picture is unclear or no picture appears.
"USE CLEANING CASSETTE" appears on the screen (only
with "O.S.D." set to "ON" (
Usable cassettes
Compact VHS camcorder recordings can be played on this
video recorder. Simply place the recorded cassette into a
VHS Cassette Adapter and it can be used just like any
full-sized VHS cassette.
This video recorder can record on regular VHS and Super
VHS cassettes. While only VHS signals can be recorded on
regular VHS cassettes*, both VHS and Super VHS signals
can be recorded and played back using Super VHS
cassettes.
* By using the S-VHS ET function, it is possible to record and
play back with S-VHS picture quality on VHS cassettes
with this recorder.

PLAYBACK

pg. 29)
on the recorder's
0
to remove the cassette.
pg. 69)).