JVC HR-S9800U Instructions Manual page 18

18
EN
5
6 7
VCR TV CABLE/DBS
1
4
7
5
2 3
7
5 6
8 9
0
6 7
INITIAL SETTINGS (cont.)
5
Select cable box output channel
Your selection depends
on how your cable box
is connected to your
VCR.
If your cable box is
connected to your
VCR's ANTENNA IN
terminal on the rear
Press CH 5∞ on the front panel or %fi on the
Remote until the channel number representing
the cable box's output (CH2 – CH9) appears on
the screen.
If your cable box is connected to your VCR's
AUDIO/VIDEO IN connectors on the front panel
Press CH 5∞ on the front panel or %fi on the
Remote until "ON F-1 (FRONT)" appears on
the screen.
If your cable box is connected to your VCR's
AUDIO/VIDEO IN connectors on the rear panel
Press CH 5∞ on the front panel or %fi on the
Remote until "ON L-1 (REAR)" appears on the
screen.
If you do not use a cable box
Press CH 5∞ on the front panel or %fi on the
Remote until "OFF" appears on the screen.
6
Access Cable Box Brand Set screen
Press OK.
7
Enter cable box brand
On the Remote ONLY:
Press the appropriate
Number keys to enter
the brand code from the
list shown to the right,
then press OK.
If the cable box's
channel changes to 9,
setting is complete
Press OK and "CABLE
BOX CONTROL IS
ON" appears on the
screen for about 5
seconds, then it
returns to the normal screen.
If the cable box's channel does not change to 9
1 Press %fi (or CH 5∞ on the front panel) to
move the highlight bar (arrow) to "NO".
2 Press OK.
3 Repeat step 7 until the cable box's channel
changes to 9 by entering another code.
4 If the channel does not change after going
through all the code numbers listed for your
model of cable box, then try all the other
numbers.
CABLE BOX SET
OFF
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END
CABLE BOX BRAND SET
1
PRESS NUMBER KEY (0–9)
THEN (OK) TO TEST
PRESS (MENU) TO END
CABLE BOX BRAND SET
1
DID YOUR CABLE BOX
CHANGE TO CHANNEL 09?
= YES
NO
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END