JVC HR-S9700EK Instruction Manual page 70

70
Set Stations (A)
Set station names that are registered in your recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 68 to access the Confirmation screen before continuing.
SELECT ITEM
1 @ #
Press %fi
until the item you want begins blinking.
ACCESS MANUAL
CHANNEL SET SCREEN
2
Press OK twice.
SELECT NEW STATION
3
#
Press until the station
name (ID) begins blinking,
then press %fi until the
new station's name (ID)
you want to store begins
blinking.
Registered station names
( pg. 71) appear as you
press %fi .
SWITCH STATIONS
4
Press OK.
The Confirmation screen appears.
Repeat steps 1 through 4 as necessary.
CLOSE CONFIRMATION
SCREEN
5
Press MENU.
PR CH ID FINE DECODER
06 CH45 – – – – +/– OFF
[ 5 ∞ ] : CHANGE ID
] : CURSOR +=
[
: OK
[MENU] : EXIT
SUBSIDIARY SETTINGS (cont.)
Set Stations (B)
Set station names other than the ones registered in your
recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 68 to access the Confirmation screen and then
perform steps 1 and 2 of "Set Stations (A)" on the left before
continuing.
SELECT STATION NAME
CHARACTER
1
#
Press until the first letter
of the station name begins
blinking.
ENTER NEW CHARACTER
2
Press %fi to cycle through the characters (A–Z, 0–9, –,
*
, +, (space) ) and stop when the desired character
is indicated, then press
characters the same way (maximum of 4).
After entering all characters, press OK.
The Confirmation screen appears.
If you make a mistake, press
character begins blinking. Then enter the correct
character by pressing %fi.
CLOSE CONFIRMATION
SCREEN
3
Press MENU.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9,
*
–, , +, (space) (maximum of 4).
PR CH ID FINE DECODER
06 CH45 BBC1 +/– OFF
[ 5 ∞ ] : A-Z, 0-9
] : CURSOR +=
[
: OK
[MENU] : EXIT
#
to enter. Enter the remaining
@
until the incorrect