Ps400 Panel Layout - Sena PS100 User Manual

Lamps
System Status
LED
Ethernet Status
LED
Serial port 1~ 2
Status LED

2.1.3 PS400 Panel Layout

The front panel of the PS400 has one power switch, one DB9 serial port connector and twelve LED
indicator lamps for status display. The lamp on the left-hand side indicates the status of the system
power-on and system ready. Next two lamps indicate statuses of 10 Base-T Ethernet Link and Act.
Eight other lamps indicate statuses of receive and transmit of each serial port. Table 2-3 describes
function of each LED indicator lamp on the panel.
The rear panel of the PS400 has one power connector, one RJ45 Ethernet connector for 10 Base-T
interface and four DB9 connectors for serial interface.
(a) The front panel of the PS200
(b) The rear panel of the PS200
Figure 2-2. The panel layout of the PS200
Table 2-2. LED indicator lamps of the PS200
Function
Turned on to RED if power is supplied
Power
Turned on to Green if system is running
Ready
Turned on to Green if connected to 10 Base-T Ethernet network
Link
Blink whenever there is any activities such as incoming or outgoing packets
Act
through the PS200 Ethernet port
Blink whenever there is any incoming data stream through the specified
Rx
serial port of the PS200
Blink whenever there is any outgoing data stream through the specified
Tx
serial port of the PS200
13