2: Getting Started; Panel Layout - Sena HelloDevice Lite Series User Manual

2: Getting Started

This chapter describes how to set up and configure the LS100W for the first time..
- 2.1 Panel Layout explai ns the panel layout and LED indicators.
- 2.2 Connecting the Hardware describes how to connect the power, the network, and the serial
device to the LS100W.
- 2.3 Accessing Console Port describes how to access the console port by using a serial console
at a local site or telnet console at a remote site.
- 2.4 Command Usages described how to use command set of the LS100W to configure and view
parameter values and status.
Following items are pre-required to get started.
- One DC power adapter (included in the package).
- One serial console cable for configuration (included in the package).
- One RS-232 serial cable for connecting the RS-232 serial device.
- One PC with Network Interface Card (hereafter, NIC) and/or one RS232 serial port.
- Terminal emulation program running on the PC
- One Ethernet cable

2.1 Panel Layout

The LS100W has five LED indicator lamps, which serve to display the current system status. The first
lamp indicates the status of system power supply and the second indicates whether the system is
currently running. The third lamp indicates the transmission status of the data communication serial
port. Lamps 4 and 5 indicate the IEEE 802.11b Wireless LAN connection and its activity, respectively.
Lamp
Status Power
Ready
Serial Ports Serial Rx/Tx
Wireless LAN Link
Act
Table 2-1 describes the function of each LED indicator lamp
Function
Turned on if power is supplied
Turned to GREEN when system is running.
Blinks whenever there is an incoming or outgoing data stream
transmits through the serial port of the LS100W.
Turned to ORANGE when connected to a Wireless LAN Network.
Blinks whenever there is an incoming or outgoing packet transmission
activity through the LS100W Wireless LAN port.
10