Ps200 Panel Layout - Sena PS100 User Manual

Lamps
10 Base-T
Serial port
Status

2.1.2 PS200 Panel Layout

The front panel of the PS200, as shown below in Figure 2-2, has one power switch, one DB9 serial
port connector and eight LED indicator lamps for status display. The lamp on the left-hand side
indicates the status of the system power-on and system ready. Next two indicate statuses of 10 Base-
T Ethernet Link and Act. Four other lamps indicate statuses of receive and transmit of each serial port.
Table 2-2 describes function of each LED indicator lamp on the panel.
The rear panel of the PS200, also as shown below in Figure 2-2, has one power connector, one RJ45
Ethernet connector for 10 Base-T interface and four DB9 connectors for serial interface.
Figure 2-1. The panel layout of the PS100
Table 2-1. LED indicator lamps of the PS100
Function
Turned on to Green if connected to 10 Base-T Ethernet network
LINK
Blink whenever there is any activities such as incoming or outgoing packets
Rx/Tx
through the PS100 Ethernet port
Blink whenever there is any incoming or outgoing data stream through the
Rx/Tx
serial port of the PS100
Turned on to GREEN if system is running.
Ready
Turned on to RED if power is supplied
Power
12