Throttle Link Lever Adjustment - Yamaha F15A Service Manual

INSP
ADJ
A
B
CONTROL SYSTEM

Throttle link lever adjustment

NOTE:
Before adjusting the throttle link lever,
make sure the throttle cables or the remote
control throttle cable are properly adjusted.
1. Check:
9 Throttle link lever
Bends/damage → Replace.
9 Adjusting screw
Loose → Adjust the throttle link lever.
9 Throttle link lever
Incorrect position → Adjust.
2. Adjust:
9 Throttle link lever
Adjusting steps:
8 Put the shift lever into the forward
position.
8 Loosen the screw 1.
8 Turn the throttle grip or set the throttle
on the remote control to the fully-
opened position so the upper stopper
2 on the throttle control cam contacts
the stopper 3 on the throttle control
cam bracket.
8 Turn the throttle link lever 4 clockwise
until it contacts the stopper 5 (this is
its fully-opened position). Then, hold it
in this position.
8 Tighten the screw.
8 Fully open and close the throttle grip
and make sure the throttle link lever
fully opens (completely lowers) and
fully closes (contacts the throttle stop
screw 6). If it does not fully open and
close properly, repeat the above pro-
cedure.
Å MH/EH models
ı E models
3-5
E