Features - Radial Engineering STAGEDIRECT User Manual

®
FEATURE SET
1
9
1. POWER SUPPLY (15VDC-400mA): Use to connect the included power
adapter.
2. LIFT: Disconnects pin-1 on the XLR output to help eliminate hum and
buzz caused by ground loops.
3. BAL OUT: Lo-Z balanced output used to feed the PA system. Follows
standard AES format with pin-1 ground, pin-2 hot (+) and pin-3 cold (-).
4. 180°: Reverses the electrical polarity at the XLR output to help eliminate
acoustic hot-spots on stage that can cause feedback.
5. REMOTE: Connection for a momentary (non-latching) footswitch that
enables remote control of the mute function.
6. TUNER: Hi-Z ¼" output allows you to connect an electronic tuner. It is
always active and can be used for silent tuning with the mute footswitch.
7. INPUT: Hi-Z ¼" input used to connect your instrument.
8. FOOTSWITCH: Mutes the stage amp output and the balanced XLR
output, leaving the tuner output active for silent adjustments on stage.
The LED's toggle from green (on) or red (mute).
9. AMP: Hi-Z ¼" output is used to feed the on-stage guitar or bass amplifi er
and is transformer isolated to eliminate noise caused by ground loops.
10. PHASE: Reverses the electrical polarity 180° at the ¼" AMP output to help
eliminate acoustic hot-spots on stage that can cause feedback.
11. PAD: Reduces the input sensitivity by -10dB to prevent overload from high
output devices like keyboards and active pickups.
12. FILTER: 3 position high-pass fi lter used to eliminate excessive bass to
help reduce feedback and low frequency resonance.
Radial Engineering Ltd.
2 3 4 5
10 11
8
2
StageDirect™ Active Direct Box
True to the Music
6
12
7