U N Packing A N D Cleaning - Delta 37-285 Instruction Manual

The 6 Motorized Jointer is shipped complete in one container. Carefully unpack the jointer, s tand, and all loose items
from the container. Figs. 4 and 5 illustrate the items supplied with the jointer.
1 . W ARNING: For your own safety, DO NOT connect the jointer to a power source until the machine is completely
assembled and you have read and understood the entire owner s manual.
2 . IMPORTA N T:When removing the jointer from the shipping container, D O N O T place the jointer on a flat surface.
Support the jointer at both ends with 4 x 4 lumber or similar material, as shown in F i g . 4 . This will prevent any dam-
age to the motor assembly, which is located on the base of the jointer.
3 . CAUTION: Carefully remove the protective coating from the machined surfaces of the jointer. D O N O T l e t y o u r
hands or fingers come in contact with the cutterhead knives as they are extremely sharp. D O N O T use acetone, gaso-
line or lacquer thinner to clean the jointer; use a soft cloth moistened with kerosene. A fter cleaning, cover the table sur-
face with a good quality paste wax.
1
18
21
1 . Jointer
2 . Belt and Pulley Guard
3 . 1/4-20 x 1/2 Truss Head
Screw (2)
4 . Guard
5 . #8-32 x 1/4 Round Head
Screw
6 . Flat Washers (2)
7 . #8-32 Hex Nut
8 . Dust Chute
9 . Cutterhead Guard

U N PACKING A N D CLEANING

11
20
16
19
17
22
1 0 . Fence Mounting Bracket
Assembly
11 . Locking Lever
1 2 . Flat Washer
1 3 . 1/4-20 x 3/4
Screws (2)
1 4 . Flat Washers (2)
1 5 . 1-1/4-20 Hex Nuts ( 2 )
1 6 . Fence Support Bracket
1 7 . Cap Screws (2)
3
4
5
12
14
15
10
23
24
25
F i g . 4
Flat Head
6
2
6
7
13
1 8 . 5/16-18 x 1-1/4 Hex Head
Screws (3)
1 9 . Flat Washers (6)
2 0 . 5/16 Hex Nuts ( 3 )
2 1 . Push Blocks (2)
2 2 . Fence
2 3 . Flat Washers (2)
2 4 . 1/4-20 x 3/4 Square Head
Screws
2 5 . W renches (4): 2.5, 5, 6mm
and 8/10mm Open-end
8
9