Carefully unpack the mortiser and all loose items from the carton. Remove the protective coating from the machined
surfaces of the mortiser. This coating may be removed with a soft cloth moistened with kerosene. Do not use acetone,
gasoline, or lacquer thinner for this purpose. Fig. 2 illustrates the mortiser and all loose items removed from the carton.
M
B
J
L
A - Mortising Machine
B - Hydraulic Cylinder
C - Raising and Lowering Handle
D - Special Screw (for raising and lowering handle)
E - Spring (for raising and lowering handle)
F - Table
G - M6 x 35mm Flat Head Screws (for assembling
table to base)
H - T-Nuts (for assembling table to base)
J - Fence
K - Bar (for mounting holddown)
UNPACKING AND CLEANING
O
N
H
G
G
K
P
F
H
C
Fig. 2
L - Holddown
M - Chuck Key
N - Wrench
O - Tool and Chisel Holder
P - M6 x 25mm Screws (for assembling tool and
chisel
holder)
* - Flat Washers (for assembling tool and chisel holder)
R - Fence Locking Handle Assembly
* - Not Shown
4
A
R
E
D