ZyXEL Communications P8701T User Manual page 201

Figure 89 802.1ag Connectivity Fault Management
The following table describes the fields in this screen.
Table 73 802.1ag Connectivity Fault Management
LABEL
802.1ag Connectivity Fault Management
Maintenance
Domain (MD)
Level
Destination
MAC Address
802.1Q VLAN
ID
VDSL Traffic
Type
Loopback
Message (LBM)
Linktrace
Message (LTM)
Set MD Level
Send Loopback
Send Linktrace
Basic Home Station VDSL2 P8701T User's Guide
DESCRIPTION
Select a level (0-7) under which you want to create an MA.
Enter the target device's MAC address to which the VDSL Router performs a CFM loopback
test.
Type a VLAN ID (0-4095) for this MA.
This shows whether the VDSL traffic is activated.
This shows how many Loop Back Messages (LBMs) are sent and if there is any inorder or
outorder Loop Back Response (LBR) received from a remote MEP.
This shows the destination MAC address in the Link Trace Response (LTR).
Click this button to configure the MD (Maintenance Domain) level.
Click this button to have the selected MEP send the LBM (Loop Back Message) to a specified
remote end point.
Click this button to have the selected MEP send the LTMs (Link Trace Messages) to a
specified remote end point.
Chapter 15 Diagnostic
201