Planet ICA-4130S User Manual page 43

Your WAN IP Address will be listed here.
3. Open/set Virtual Server Ports to enable remote image viewing
The firewall security features built into the router and most routers prevent users from accessing
the video from the device over the Internet. The router connects to the Internet over a series of
numbered ports. The ports normally used by the device are blocked from access over the Internet.
Therefore, these ports need to be made accessible over the Internet. This is accomplished using
the Virtual Server function on the router. The Virtual Server ports used by the camera must be
opened through the router for remote access to your camera.
Follow these steps to configure your router's Virtual Server settings
Click Enabled.
Enter a unique name for each entry.
Select Both under Protocol Type (TCP and UDP)
Enter your camera's local IP Address (192.168.0.100, for example) in the Private IP
field.
If you are using the default camera port settings, enter 80 into the Public and
Private Port section, click Add.
A check mark appearing before the entry name will indicate that the ports are enabled.
Some ISPs block access to port 80. Be sure to check with your ISP so that you
can open the appropriate ports accordingly. If your ISP does not pass traffic on
port 80, you will need to change the port the camera uses from 80 to something
else, such as 8080. Not all routers are the same, so refer to your user manual
for specific instructions on how to open ports.
Ultra-mini SIP PoE IP Camera
44
ICA-4130S/ICA-4230S