Pitco ME14S-C/MFD Service Manual page 3

SAFETY
The fryer must be electrically grounded in accordance with local codes. If local codes do not apply
follow the requirements of National Code ANSI/NFPA 70-1990
Before connecting any fryer make sure that all the circuit breakers for the appliance(s) are OPEN or
OFF. NEVER connect the fryer with power applied to the power lines. Some appliances have more
than one power supply. Make sure they are ALL disconnected.
The heating elements MUST be covered with water or oil before they are turned on. NEVER turn
on the fryer unless the elements are covered by at least one inch of liquid. For the Element Burn OFF
Proceedure refer to the operation manual.
Never melt blocks of shortening on top of the heating elements. This will cause a fire, and void your
warranty.
Water and shortening DO NOT mix. Keep liquids away from hot shortening. Dropping liquid frozen
food into the hot shortening will cause violent boiling.
At operating temperature the shortening temperature will be greater than 300°F. Extreme care
should be used when filtering operating temperature shortening to avoid personnel injury.
Follow the filtering proceedures carefully when filtering, these can be found in the operating manual.
Before handling any parts after filtering make sure they have cooled to room temperature.
All power supplies must be disconnected before servicing. Some appliances have more than one
power supply. Make sure they are ALL disconnected.
NEVER remove the entrance box cover unless all power to the appliance has been disconnected.
SAFETY
SAFETY
DANGER - HIGH VOLTAGE PRESENT
SAFETY
SAFETY
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
SAFETY
SAFETY
SAFETY
SAFETY
SAFETY