Advertisement
Replacing the lamp in your Pylon
Y
our Pylon is illuminated by one lamp. During the course of normal operations,
this lamp may require replacement. Follow these steps to replace the lamp with Lionel
part no. 671-4217-300.
1. Lift the support arm out of the tubes at the top of the pylon. Also, remove any screws
securing the base to your layout.
2. Remove the four base screws from the underside of the base with a small Phillips-head
screwdriver and lift away the roof and pylon tower. Refer to Figure 5 on page 10 for the
location of the screws.
3. Locate the lamp inside the building. Carefully unscrew the lamp from the socket. Refer to
the Figure 6 on page 11 for the lamp location.
4. Install the replacement lamp.
5. Reassemble the Pylon, following these steps in reverse order.
9
Advertisement
