Advertisement
Attaching the witch to your Pylon
C
omplete the assembly of your Pylon by attaching the witch and support rod to the
structure. Figure 2 illustrates the following procedure.
1. Note that the supporting rod has different shaped ends. Insert the D-shaped coupling
bottom end of the support rod onto the D-shaped mounting post on the top of the pylon.
Refer to the diagram for further assistance.
2. Insert the D-shaped top end of the rod into the D-shaped opening in the bottom of the
witch.
D-shaped coupling
support rod (bottom)
D-shaped mounting
post on top of pylon
Figure 2. Installing the support rods
Operating your Pylon with a conventional power supply
A
djust the voltage to the accessory to control the speed at which the witch circles the tower.
Increasing the voltage will cause the witch to circle faster; decreasing the voltage will
cause the witch to travel slower. To turn the accessory off, turn off the power supply or use the
switch attached to the wires in Step 1 on page 3.
D-shaped
mounting hole,
bottom of witch
D-shaped
support rod (top)
6
Advertisement
