Table of Contents
Related Manuals for Digi E230
Summary of Contents for Digi E230
- Page 1 Guide User BROADBAND E230 HSPA USB MODEM DiGi Telecommunications Sdn Bhd 201283-M Lot 10, Jalan Delima 1/1, Subang Hi-Tech Industrial Park 40000 Shah Alam, Selangor Darul Ehsan, Malaysia Enquiries: 016 299 3333 / 1 800 68 3333 or digi.com.my...
- Page 2 ‘Modem not found’ appears. What should I do? A : Your PC could not detect your modem or could not recognise the modem’s driver. Please remove and re-plug the modem into the USB port. Broadband E230 HSPA USB Modem...
- Page 3 Q : After I plug in the modem, it fails to prompt me to perform the Connection Huawei Technologies Co., Ltd. Manager installation. What should I do? A : Go to My Computer > DiGi Internet drive and locate the ‘Setup.exe’ file. Trademarks and Permissions Double-click it and it should launch the installation process.
-
Page 4: Table Of Contents
Broadband Customer Service at 016 299 3333 or 1 800 68 3333 check if Table of Contents your subscription is active. Getting to Know the E230................1 Q : I am experiencing slow Internet browsing speed. It takes ages for each page to load. -
Page 5: Getting To Know The E230
The electromagnetic waves emitted from the PC may interfere with wireless signals. When the signal is weak or the transmission rate is low, you are recommended to use the long USB cable provided with the E230 and change the position of the E230 to receive stronger signals. - Page 6 Q : How do I know that I am connected via the DiGi 3G connection? 1. Indicator A : Please refer to the signal bar icon at the bottom left of the Connection Indicates the status of the E230 Manager window. It indicates whether it is connected to a GPRS, EDGE or UMTS/WCDMA/HSDPA network.
-
Page 7: Requirements For The Pc
Requirements for the PC 2. Go to ‘Tools’ > ‘Options’ > ‘Profile Management’ To use the E230, the PC must meet the following requirements: • Standard USB interface 3. In the ‘Profile Management’ window, perform the setup as below: • Windows 2000 SP4, Windows XP SP2, Windows Vista, Mac OS •... - Page 8 Green a GPRS network Using the Clip A clip is provided in the package of the E230. When you connect the E230 to a The modem is connected to Blue laptop, you can fix the E230 to the clip, and hang the clip on the laptop.
-
Page 9: Installation Guide
• Hard Disk: 50MB free disk space Note: • Operating System: Windows XP/Windows 2000/Windows Vista / Power on your PC before connecting the E230 with the PC. Otherwise, the normal Mac OS X version 10.4.3 installation of the E230 may be affected. - Page 10 Launching the Management Program After the E230 is installed, the management program is launched automatically. Then every time the E230 is connected to the PC, the management program is launched automatically. You can also double-click the shortcut icon on the desktop to launch the...
-
Page 11: Acronyms And Abbreviations
The Unplug or Eject Hardware interface is displayed Acronyms and Abbreviations 2. Select the hardware related to the E230 and click Stop 3. When the prompt "It is safe to remove the device" is displayed, remove the E230 Numeric The Third Generation Note: Before removing the E230, exit the management program. -
Page 12: Safety Information
Note: Safety Information For details about setting the profile, contact your service provider. Read the safety information carefully to ensure the correct and safe use of your wireless device. Creating a Dial-up Profile 1. Click New to set the profile name, access number, user name, password, Access Interference Point Name (APN) and APN status Do not use your wireless device if using the device is prohibited or when it causes... - Page 13 • Area indicated with the "Explosives" sign 1. Click the Network Type tab • Area indicated with the "Power off bi-direction wireless equipment" sign 2. In the Network Type drop-down combo box, select the corresponding network type • Area where you are generally required to stop the engine of a vehicle 3.
-
Page 14: Network Settings
WEEE Approval 1. Choose Tools > Choose Device 2. Select a device in the device list The wireless device is in compliance with the essential requirements and other 3. Click OK to terminate the current terminal and switch to the selected one relevant provisions of the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE Directive). - Page 15 • Do not leave your wireless device and accessories in a place with a considerably Entering the PIN Code low or high temperature. When the PIN Verification is enabled, you need to enter the correct PIN code to use • Use only accessories of the wireless device approved by the manufacturer. the network-related functions.
-
Page 16: Regulatory Information
DG 158337 Broadband_UserGuide_E230_R1_22-15 FA size: 12cm(H) x 24cm(W) Failure to observe these instructions could result in your RF exposure exceeding the Settings and Information Query relevant guideline limits. Regulatory Information PIN Operations The following approvals and notices apply in specific regions as noted. If a SIM/USIM card is used on the terminal, the Personal Identity Number (PIN) code protects your card from unauthorised use. - Page 17 Software Manual • Transfer: To view the duration of the current connection, uploaded/downloaded speed and data of the current connection • Statistics: To view the last reset time, daily/monthly/yearly uploaded and downloaded data Note: The statistical data of the traffic is only for your reference. The actual traffic information is accounted on the basis of the traffic data collected by the operator.
-
Page 18: Internet Services
Internet Services Accessing the Internet After setting the network and connection profiles, you can access the network through the Terminal Management. To access the Internet, do as follows: Contents 1. Click 1 Description of the Terminal Management GUI........... 1 2. Select the correct profile in the drop-down list Launching the Terminal Management............ -
Page 19: Interface Overview
The following table lists the shortcut icons provided by the Terminal Management. Click… To… Display the Connection interface Query the statistics of the transferred data Access the Internet and connect to the website: www.myinternet.com.my Access the Internet and connect to the website: www.digi.com.my...
Need help?
Do you have a question about the E230 and is the answer not in the manual?
Questions and answers