Table of Contents
Advertisement
8.4
Option settings
8.4.1
Introduction
The microprocessor communicates with a large number of
(I2C) ICs in the set. To ensure good communication and make
digital diagnosis possible, the microprocessor has to know
which ICs to address. The presence or absence of specific ICs
or functions is made known by means of the option codes.
8.4.2
Dealer Options
Select this sub-menu to set the initialisation codes (= options)
of the set via text menu's.
Menu name
Subjects
Personal
Picture Mute
Options
Virgin Mode
Auto Store
Mode (for EU)
Txt Preference
(for EU)
Note: Above overview gives the menu items for all regions (EU/AP/US). The correct settings differs per region (see Option Numbers).
Electrical Alignments
Options
Physically in set
Yes
Video mute active when there is no signal detected
No
Noise when there is no signal detected
Yes
TV starts up with language selection menu
No
TV does not start up with language selection menu
None
Auto Store mode disabled (not in installation menu)
PDC-VPS
Auto Store mode via ATS (Automatic Tuning System) enabled
TXT page
Auto Store mode via ACI (Automatic Channel Installation) enabled
PDC-VPS-TXT
Auto Store mode via ATS or ACI enabled
FLOF
Preference to FLOF (Full Level One Features) teletext
TOP
Preference to TOP (Table Of Pages) teletext
Figure 8-3 Dealer options overview
F21RE AB
All options codes can be manipulated using both the Option
Numbers and/or the Option menu.
All hardware related options are incorporated under the
heading SERVICE OPTIONS in the SAM main menu.
All software related options are incorporated under the heading
DEALER OPTIONS in the SAM main menu.
After you have changed the option(s), save them via the
STORE OPTIONS command. The new option setting is only
active after the TV is switched OFF and ON again via the mains
switch (the EAROM is then read again).
8.
EN 83
CL 36532021_014.eps
310303
Advertisement
Table of Contents
