Programming The Alarm Feature - Norstar Modular ICS 7.0 System Manual

Programming the alarm feature

If you want to allow the room sets to program wake-up alarms,
there are a couple of program settings that need to be entered.
1. Place the appropriate programming overlay on the set you
are using to do programming.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ¤‹fl›fl (ADMIN). The display shows
Terminals&Sets.
4. Press ' until the display shows Hospitality.
5. Press ≠. Room/desk info displays.
6. Press ' until Alarm displays.
7. Press ≠. Attn attempts:3 displays.
8. Press CHANGE until you find the number you want (1-5).
9. Press '. Retry intrvl:4 displays.
10. Press CHANGE until you find the number you want (2, 4, 6,
or 8).
11. Press '. Attn duration: 15 displays.
12. Press CHANGE until you find the number of seconds you
want (10, 15, 20, 30, 40, 50).
13. Press '. Time format:12 hr displays.
14. Press CHANGE to choose either 12hr or 24hr.
15. Press '. Expired alarms displays.
16. Press ≠. Notify set:None displays.
17. Press CHANGE to enter a set DN to be notified.
18. Press '. Use tone: N displays.
N0000626 03
Programming the alarm feature / 187
Modular ICS 7.0 System Coordinator Guide