Sherwood RD-6505 Operating Instructions Manual page 21

RD-6505(A)_100223_RD-5503(g) 2010-05-11 오전 9:52 페이지 21
Adjusting the current channel level
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or
to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user's memory
("CAL"), not into preset memory("REF 1", "REF 2").
1.
Press the CHANNEL LEVEL button.
CH.LEVEL
• Then the memory mode ("CAL", etc.) is displayed for
several seconds.
• When the memory mode or channel level disappears,
press this button again.
2.
Select the desired channel.
PRESET
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
→ REF 1, 2 (or CAL) ↔ FL ↔ C ↔ FR ←
→ <DTS or DD> ↔ SW ↔ SL ↔ SR ←
< >: Only when the digital signals from Dolby Digital or DTS
program sources are input, these levels can be displayed.
• Depending on the speaker settings ("N (No)") and
surround mode, etc., some channels cannot be
selected.
• When the SPEAKER button is set to off, only the Front
Left and Front Right channels can be selected.
3.
Adjust the level of the selected channel as
desired.
TUNE
• The LFE level can be adjusted within the range of -10 ~
0 dB and other channel levels within the range of -15 ~
+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the setting
as necessary.
4.
Repeat the above steps 2 and 3 to adjust each
channel level.
21