Operations; Listening To A Program Source; System Setup - Sherwood RD-6505 Operating Instructions Manual

RD-6505(A)_100223_RD-5503(g) 2010-05-11 오전 9:52 페이지 15

Operations

■Note : Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup
procedures. (For details, refer to "System Setup" on page 28.)

LISTENING TO A PROGRAM SOURCE

Before operation
• Enter the standby mode.
• The STANDBY indicator lights up.
This means that the receiver is not
disconnected from the AC mains and a
small amount of current is retained to
support the operation readiness.
• To switch the power off, push the POWER
switch again.
• Then the power is cut off and the
STANDBY indicator goes off.
1.
In the standby mode, turn the power on.
ON/STANDBY
• Each time the POWER ON/STANDBY button on the
front panel is pressed, the receiver is turned on to enter
the operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY
button to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR button
is pressed, the receiver is turned on automatically and
the desired input is selected.
2.
Switch the speakers on.
• Then "SPK ON" is displayed and the sound can be
heard from the speakers connected to the speaker
terminals.
• When using the headphones for private listening, press
the SPEAKER button again to switch the speakers
off("HP ON" is displayed).
3.
Select the desired input source.
POWER
INPUT
VIDEO AUDIO
• Each time the "VIDEO" button on the front panel is
pressed, the input source changes as follows:
VIDEO 1 ↔ VIDEO 2
• Each time the "AUDIO" button on the front panel is
pressed, the input source changes as follows:
→ CD → AUX1 → AUX 2 → TAPE → BT → Tuner
• Each time the BAND button(or the TUNER button on the
remote control) is pressed, the band changes as follows:
→ FM ST → FM MONO → AM
When CD, VIDEO 1~ 2 is selected as an input source
4.
Select the digital or the analog input connected as desired.
AUDIO ASSIGN
• Each time this button is pressed, the corresponding input
is selected as follows:
→ o(ptical) → c(oaxial) 1 → c(oaxial) 2 → A(nalog)
■Notes :
• When the HDMI IN connector is connected to your video
component, you cannot assign the audio input as desired. (It
means that only the HDMI digital audio signals can be heard.)
• When AUX 1, AUX 2, TAPE, BT or tuner is selected as an input
source, the digital input cannot be selected.
• When the selected digital input is not connected, the "DIGITAL"
indicator flickers and the analog input is automatically selected.
• The selected digital input or analog input is automatically
assigned to the corresponding input source on the INPUT setup
menu. (For details, refer to "SETTING THE INPUT" on page 32.)
• The sound from the component connected to the selected digital
input can be heard regardless of the selected input source.
15
BAND
(Frequency display)