Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Baumatic CAN52.3ME
Summary of Contents for Baumatic CAN52.3ME
- Page 1 CAN52.3ME CAN75.3SS Canopy hood...
- Page 2 User Manual for your Baumatic CAN52.3ME 52 cm CAN75.3SS 75 cm Canopy Hood NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
-
Page 3: Table Of Contents
IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your cooker hood 8 – 10 CAN52.3ME CAN75.3SS Using your Baumatic cooker hood 10 - 11 Before first use To use your cooker hood 10 - 11 Cleaning your Baumatic cooker hood 11 –... -
Page 4: Environmental Note
Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person. o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment. -
Page 5: Important Safety Information
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line. - Page 6 o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
- Page 7 o Remember that when in extraction mode, your cooker hood is removing air from your room. Ensure that proper ventilation measures are being observed. o Note that it removes odours from your room, not steam. o Warning - Always ensure that the cooker hood been disconnected...
-
Page 8: Specifications Of Your Cooker Hood
Specifications of your cooker hood CAN52.3ME Product dimensions Height: 166 mm Width: 520 mm Depth: 321 mm Your canopy hood is fitted with: o Slider control operation o Integrated axial motor o 3 speeds o 1 washable aluminium grease filter... -
Page 9: Can75.3Ss
CAN75.3SS Product dimensions Height: 245 mm Width: 746 mm Depth: 296 mm Your stainless steel canopy hood is fitted with: o Slider control operation o Integrated axial motor o 3 speeds o 1 washable aluminium grease filter o No-return airflow flap o 2 halogen lights o Noise level: 61 / 65 / 68 dB Extraction capacity:... -
Page 10: Using Your Baumatic Cooker Hood
All of the optional extras are available from the Baumatic Spares Department. Using your Baumatic cooker hood Before first use IMPORTANT: THIS PROCESS MUST BE FOLLOWED BEFORE THE COOKER HOOD IS USED FOR THE FIRST TIME. o You should use a good quality stainless steel cleaner on ALL of the stainless steel areas of your cooker hood, before it is used for the first time. -
Page 11: Cleaning Your Baumatic Cooker Hood
2) Motor speed control. = Low speed = Medium speed = High speed IMPORTANT: IDEALLY YOU SHOULD SWITCH ON YOUR HOOD TEN MINUTES BEFORE YOU START TO COOK, OR AT THE VERY LEAST WHEN YOU BEGIN COOKING. YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING. -
Page 12: The Grease Filter
The grease filter o Your cooker hood includes a grease filter which helps to absorb grease particles to protect your kitchen and furniture from greasy residues. o The metallic filter may become flammable if it becomes saturated with greasy residue. o To prevent this fire hazard, the filter should be cleaned regularly. -
Page 13: Changing A Light Bulb
o Refit the grease filter once it has dried. o IMPORTANT: Let the grease filter dry thoroughly before refitting it in the cooker hood. Changing a light bulb IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY. -
Page 14: Fitting The Carbon Filters
o Insert a new identical 40W (max) bulb. o IMPORTAN T: Defective bulbs should be replaced immediately. o If the lights still do no t work, make sure that the bulbs are fitted properly into their housings before you call for technical assistance. - Page 15 2) Hook the carbon filter over the pins that are located at the end of the motor. ) Turn the carbon filter clockwise until you feel it latch nto the motor’s sides. 4) Replace the grease filters. o When replacing the carbon filter, follow the steps outlined above and turn the carbon filter anti-clockwise to unlatch it from the motor.
-
Page 16: Installation
Installation Installation IMPORTANT: Before installation read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated on the rating plate are exactly the same as the voltage and frequency in your home. The rating plate can be found behind the grease filters. -
Page 17: Before Beginning Installation
lue = Neutral Brown = Live You will find only find two wires in the main ’s lead (blue and rown); neither must be connected to the earth terminal. o As the colours of the wires in the appliance’s mains lead may not correspond with the coloured markings identifying the terminals in your spur box,... -
Page 18: Installing Your Cooker Hood
REST INSTALLATION PROCESS HAS BEEN COMPLETED. ) Remove the metal grease filter (A). ) Create an opening in the underneath of the kitchen unit; the cut- out must be of the dimensio ns shown in the drawing below. CAN52.3ME CAN75.3SS... - Page 19 o IMPORTANT: If you are going to connect y our cooker hood to external ducting, then you must complete the steps listed in the “Connecting to external ducting” section before carrying on with the rest of the installation (this information can be found on page 20).
-
Page 20: Connecting To External Ducting
The discharge outlet should have a cross section of at least 150 cm² (please note that the ducting hose is not supplied with the appliance but one can be obtained from the Baumatic Spares Department). o The maximum distanc... -
Page 21: Extraction Mode Or Recirculation Mode
operating correctly by selecting each speed and switching the light bulbs on and off. xtraction mode or recirculation mode? IMPORTANT: YOU WILL HAVE TO DECIDE BEFORE INSTALLING YOUR COOKER HOOD WHETHER TO USE EXTRACTION MODE ECIRCULATION MODE. What is the difference between extraction and recirculation modes? In extraction mode, the stale air will... -
Page 22: Troubleshooting
o I need a charcoal filter? All cooker hoods have a grease filter but if you are using y our cooker hood in recirculation mode, then charcoal filters must be fitted in addition to the grease filter. roubleshooting PORTANT: If your cooker hood appears not to be operating roperly, before contacting the Customer Care Department, please refer to the table below. - Page 23 Or any installation other han the one specified by Baumatic Ltd. has been completed. lease refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
-
Page 24: Contact Details
Kingdom zech Republic aumatic Ltd., Baumatic CR s.r.o. aumatic Buildings, ípovà 665 Bennet Road, 460 01 Liberec 4 eading, Berkshire zech Republic G2 0QX nited Kingdom +420 483 577 200 Sales Telephone www.baumatic.cz (0118) 933 6900 Sales Fax Slovakia (0118) 931 0035 aumatic Slovakia, s.r.o.
Need help?
Do you have a question about the CAN52.3ME and is the answer not in the manual?
Questions and answers